ROI CALCULATOR

The cost of manual redaction

Hand-masking a log file is slow and error-prone, and even the best system administrators make mistakes under pressure. What does that cost your organization?

HAR capture (browser devtools) Application log (10k lines) Enterprise support bundle

Redaction by hand

Lines in the file 10,000

An application log is usually 5,000 to 50,000 lines, and a HAR file 30,000 to 100,000 or more. An enterprise support bundle (for example, ISADC) can hold hundreds of thousands to millions of lines in thousands of files.

Lines you would review by hand 1,000

A careful reviewer gets through the main log and configuration files, usually a few thousand to tens of thousands of lines. The rest goes unreviewed.

Lines reviewed per minute (manual) 30

A careful review for sensitive data covers about 20 to 40 lines a minute, depending on how verbose the log is.

Loaded hourly rate (the person doing it) $120 / hr

A senior engineer or solutions architect usually costs $100 to $175 an hour, loaded.

Support tickets a year that need redaction 12

Count only the tickets you opened. The next field counts the ones you didn't open because of redaction.

Tickets not opened because of redaction 4

Teams often skip a ticket when they know support will ask for logs they can't safely send.

Extra downtime per unopened ticket (hours) 8

How much longer the problem lasts when the ticket is opened late or never. Set it to 0 to leave this out.

Business cost of downtime (per hour) $500 / hr

Lost revenue, SLA penalties, or engineering hours spent working around the problem. Set it to $0 to leave this out.

Estimated cost if a PII or CUI leak is found $250,000

IBM's Cost of a Data Breach report puts the average breach at about $4.4 million, so this default is a conservative floor for one incident. Set it to $0 to count only time and labor.

Time saved per incident

—

Set your inputs to see the estimate.

Manual coverage —
Hand-reviewed Redactifire (100%)

Incomplete support cases

With manual review, you send IBM (or your vendor) only the part of the bundle you had time to check. Redactifire processes the whole bundle in minutes, so support gets all of it. Cases close sooner, with fewer requests for more data.

Residual breach risk per incident (unreviewed lines)

—

Labor cost saved per incident

—

Annual projection (12 opened, 4 not opened)

Hours saved (redaction)
—
Lines left unreviewed a year
—
Labor cost saved
—
Breach exposure reduced
—
Downtime cost prevented
—

Total annual cost recovered

—

Labor saved, plus breach exposure reduced, plus downtime cost prevented.

Methodology and assumptions

Time saved is how long a person would spend reviewing the lines they would check, minus Redactifire's processing time (seconds to minutes, depending on bundle size). Redactifire processes the whole file. Manual review stops where attention runs out.

Breach risk exposure is your incident cost multiplied by the share of lines that go unreviewed. It estimates exposure in proportion to what goes unreviewed. It is not the probability of a breach. If 90% of the file goes unreviewed, 90% of a potential incident cost is still at risk. Set it to $0 to count only time and labor.

Downtime from unopened tickets is a cost the ticket count misses. Teams often skip a ticket when they know support will ask for logs they can't safely send, so the problem stays unresolved longer. The calculator models it as unopened tickets × extra hours unresolved × hourly business cost.

All figures are estimates based on your inputs. Actual time depends on how verbose the logs are, how well the engineer knows them, and how thorough the redaction is. The estimate is conservative: it leaves out the rework when a reviewer misses something and the file must be sanitized again.

The demo takes under a minute, and you don't need an account.